Reasons for the blockage of the vibration plate:
1. The product is too thin and the vibrating plate manufacturing accuracy is not good, resulting in poor accumulation and material clamping. In this case, only high technology is required. Wire cutting and computer gongs are used to make high-precision objects and tracks.
2. There is a reverse material situation caused by jamming or right or wrong commodity benefits. This situation can only go back to the factory;
3. The material path is not smooth and has burrs, or the material path is not smooth and the curvature is too small. This situation is a matter of experience with the plate swing machine. There is no other way but to deal with it according to the situation.
4. The vibration of the vibration plate is too large or too small. If this is a good material, it is best to use an FM controller.
There is a pulse electromagnet under the vibrating plate hopper, which can make the hopper vibrate in the vertical direction, and the oblique spring plate hopper torsionally vibrates around its vertical axis. Due to this vibration, the parts in the hopper rise along the spiral track. In the ascent process, after a series of trajectory selection or posture changes, the parts can actively enter the assembly or processing direction according to the assembly or processing requirements. The purpose of its work is to send disordered workpieces to the next process in an active, orderly, directional, regular and accurate manner through vibration.
1. The spring is broken
2, the bottom is too thin
3. The appearance is defective and lacks hardness. If the equipment table is suspended, the vibration will be too weak. The thickness of the table should be 1-1/2”, so there is no vibration. It is necessary to equip the cylindrical legs with triangular brackets.
4. The voltage is unstable and the grid is jittery
5. There are fragments in the plate.
6, uneven ground
7. The vibration plate of the machine parts is too fast.
8. Parts out of tolerance, irregularity, poor consistency, distortion, oil leakage, etc.
9. The controller needs the adjusted power jitter. Adapt to the grid
10. The air gap of the coil should be as small as possible.
11. The fastening screws of the board and the base are not fastened or incorrect.
12, too many parts
Post time: Aug-31-2022